Relay 5v 2 Channel 10A 250V แบบ Active High/Low

Relay 5v 2 Channel 10A 250V แบบ Active High/Low สามารถเลือกให้ทำงานได้ทั้ง Active HIGH / Active LOW เพียงแค่เซ็ตจัมเปอร์ที่ตัวบอร์ดเลือก High/Low Description: 1) the module uses the original loose music relay, normally open interfaces Maximum load: AC 250V / 10A, DC 30V /. 10A 2) using the original Toshiba SMD optocoupler isolation, driving ability, stable performance; trigger current 5mA 3) Operating voltage 5V 4) the power indicator (green), relay status indicator (red) 7 , the power indicator light (green), the relay status indicator (red) 7 , the module can be set by the jumper high or low level trigger 5) fault-tolerant design, even if the control line break, the relay will not move; 6) the module size: 50mm * 41mm * 18.5mm (length * width * height) 7) with four fixed bolt holes, holes 3.1, the interface design is user-friendly, all interfaces can be directly connected through the terminal leads, very convenient 8) Mm, spacing 44.5mm * 35.5mm Interfaces: 1) DC +: then the power supply positive (voltage according to the relay requirements 5V) 2) DC-: then the power supply negative 3) IN1: 1 signal trigger side, you can set the high or low level control relay pull 4) IN2: Trigger side, you can set the high or low level control relay pull Relay output: 1) NO1: 1-way relay normally open interface, the relay before the pull-off, after the connection with COM1 short 2) COM1: 1 relay common interface 3) NC1: 1 relay normally closed interface, the relay before the convergence with COM1 short, pull after the floating 4) NO2: 2 relay normally open interface, the relay before the suspension, after absorbed and COM2 shorted 5) COM2: 2 relay common interface 6) NC2: 2-way normally closed relay interfaces, relay before and COM2 short, after the pull-vacant