K1 Relay Switch 1 Channel One Way Servo สัญญาณสําหรับเครื่องบินควบคุมระยะไกล

High Voltage 1CH PWM Signal Relay Switch Navigation Light Controller for Aircraft Remote Control Relay RC Toy Description:  Small size and light weight  Adopt transparent heat-shrinkable rubber, stylish appearance, at a glance  Input channels do not need to be calibrated, compatible with various brands of remote control devices  With boot protection, easy to operate  Support 5-9v high voltage receivers.  1 channel servo signal input, control one way electronic switch  Maximum 10A30VDC  Two LEDs indicate working status  Increased no signal protection Application range:  Remote control model rocket launch  Remote control model smoke control  Weapon system control like real machine  Model aircraft's smoke control  Control of various remote switch systems  Switch the signals of two cameras  Control the opening and closing of various electrical power sources, such as navigation lights, searchlights, strobe lights, buzzers, etc.  Control the camera shutter or switch the camera's recording and camera mode. Functional Description:  The remote switch remotely controls the electrical equipment on the aircraft model through a switch channel on the remote control, and the 1-way LED dynamically demonstrates the current switch state in real time, so it can be quickly started without an operation manual.  This device does not require calibration and can be accurately compatible with remote control devices of various brands. Typical application: 1. Connect  Plug the signal input cable into an idle receiver channel (recommended for the two-stage switch channel), which corresponds to a switch on the remote control.  The red indicator light will be illuminated when connected to the receiver.  The blue work indicator lights up when the switch channel is open, and vice versa. 2. Working mode  The red LED is always on; the signal is normal. The red LED light flashes; no signal.  The blue LED indicates the relay's operating status. 3. Trigger  Turn the switch on the remote control (OFF->ON), the blue LED lights up and the relay starts to work.  Turn the switch on the remote control off (ON-> OFF), the blue LED will go out and the relay will not work. Package:  1x K1 Relay Switch