Isolation 817 PC817 Optocoupler Optical Isolation Module 2 ,4 ,8 ช่อง โมดูลควบคุมแบบแยกกราวน์

โมดูลนี้ใช้ IC 817 ในการควบคุม สามารถควบคุมสัญญาณแบบ PWM ที่ความถี่สูงสุด 3Khz Description: This module is used when it is necessary to isolate the control in actual work and voltage conversion. It can realize 3.3V or 5V control 3.3---30V voltage level interface, after the control terminal input high level is turned on, the controlled terminal will also conduct to the ground, and the port changes from the original high level to the low level. For the friend of the single-chip or PLC, it is only necessary to judge when the output port is low. The photoelectric isolation has strong anti-interference ability, and the combination control of many different devices can be realized later, such as triode, MOS tube, and small power relay module. If it is a pulse signal, please note that the limit of 817 is below 3KHZ. If the control signal is greater than 3KHZ, please do not use this module, it will not work properly. Parameter: 1, the drive terminal signal voltage: 3.3-24V 2, the output voltage range: 3.3-30V (output current depends on the specific situation, but the maximum is not 10MA, the total power is certain, the voltage and current are inversely proportional) 3, through the jumper cap can achieve whether the output is high potential output or low output. 4, the board above 2 / 4 / 8 817 are independent, can achieve simultaneous control of different voltages, etc. 5: board size: length: ( 2 ช่องขนาด 2.9*3.8 ซม.) ( 4 ช่องขนาด 3.9*4.8 ซม.) ( 8 ช่องขนาด 3.9*8.5 ซม.)